Pages

Showing posts with label acura. Show all posts
Showing posts with label acura. Show all posts

Friday, April 25, 2014

How to Clear a Service Engine in an Acura

How to Clear a Service Engine in an Acura

Your Acura generates and stores fault codes whenever there is a problem with a solenoid, valve or sensor. This will show up on your instrument panel as "Service Engine" or other warning light. Once you have the codes checked and the vehicle serviced by a qualified mechanic, you need to clear the codes. Usually the mechanic can and will do this, but not always. Not only is it annoying to have the light remain on your instrument panel, it is also bad for the vehicles computer, which may not able to keep track of when your next servicing is due. You dont need any special tools to clear the service engine light on your Acura. Its a relatively easy fix.

Instructions

    1

    Put the key into the ignition and turn the engine to the "off" position on your Acura.

    2

    Find the reset button on the odometer located on the instrument panel. Press and hold this button while simultaneously turning the key in the ignition to the on or "II" position.

    3

    Hold the button for about 10 to 15 seconds, then release it. The "service engine soon" light will go out.

    4

    Turn off the vehicle, then turn the engine on. Verify that the "service engine soon" light is still off.

ReadMore

Tuesday, September 17, 2013

How to Replace the Muffler on an Acura Integra

Sold as a Honda in most parts of the world, but sold as the Acura Integra in the U.S. was only available from 1986-2001. This sporty car was mostly sold as a hatchback and was meant to compete with other compact of the time. Doing the easier repairs, such as replacing a bad muffler can save you money. If you hear noises coming from this part, then consider replacing it.

Instructions

    1

    Crawl under the car and check to see if the muffler has a welded installation or a clamped installation. A clamped installation will have bolts that hold the muffler in place. A welded installation will not have any bolts.

    2

    Remove the bolts with the screwdriver or wrench if the muffler is clamped on. If you are unfortunate enough to have a welded muffler, purchase an exhaust cutting tool or a blow torch to remove it.

    3

    Position yourself under car to replace the muffler. You may want to place a piece of cardboard or an old blanket on the ground so that you are not lying on the ground. You do not need to use jacks to replace the muffler.

    4

    Remove the old muffler from the car. You can simply bang it off of the car using a sledge hammer. You can also use a hand saw to remove it if necessary.

    5

    Compare the old tail pipe with the new one. You may have to saw off some of the tail pipe so that it closely measures about the same as the old one. You dont want your tail pipe sticking out too far.

    6

    Install the new muffler on your Acura Integra. Line it up straight with the clamps and then tighten the bolts to hold it in place. The bolts shouldnt be too tight-you want the muffler to move slightly to prevent damage.

ReadMore