Repair And Fix it

home» 2002 » 300 » a » belt » gs » how » lexus » on » replace » the » timing » to » How to Replace the Timing Belt on a Lexus 2002 GS 300

---

How to Replace the Timing Belt on a Lexus 2002 GS 300

The Lexus GS is a mid-size luxury sedan that has been in production since 1993. The 2002 model is a second generation Lexus, which includes the 1997 through 2005 models. The 2002 Lexus GS 300 has a six-cylinder 3.0-liter engine with a double overhead camshaft. This type of engine uses a timing belt to synchronize the rotations of the crankshaft and camshaft. The timing belt should last at least 60,000 miles before requiring replacement.

Instructions

1

Remove any components needed to access the upper timing belt cover. Disconnect the eight mounting bolts on the upper timing belt cover with a socket wrench and remove the upper cover.

2

Turn the crankshaft clockwise with a hex wrench to align the timing mark on the crankshaft pulley with the timing mark on the crankcase. The timing marks on the camshaft pulleys must also align with the timing marks on the lower timing cover.

3

Disconnect the timing belt tensioner and its dust cover with a socket wrench. Remove the lower timing belt covers and the guide for the timing belt. Rotate the pulley for the right camshaft clockwise slightly to relieve the tension on the timing belt, and detach the timing belt from its pulleys.

4

Replace the lower timing cover and fasten its mounting bolts with a socket wrench. Turn the right camshaft pulley clockwise to align its timing mark with the corresponding timing mark on the lower timing belt cover. Turn the left camshaft pulley clockwise to align its timing mark.

5

Place the new timing belt onto the crankshaft pulley. Align its installation mark with the edge of the lower timing belt cover.

6

Place the timing belt on the left camshaft pulley and align the left camshaft timing mark on the timing belt with the timing mark on the left camshaft. Align the timing mark on the left camshaft with its corresponding mark on the lower timing belt cover. Repeat this step with the right camshaft.

7

Place a plate washer between the engine block and the timing belt tensioner. Press the push rod for the tensioner into its housing to align the hole in the push rod with the hole in the housing. Insert a 0.05 inch Allen wrench into the holes to hold the push rod in place.

8

Replace the dust cover for the tensioner, and install the tensioner. Tighten the mounting bolts for the tensioner to 20 ft- lbs. with a torque wrench. Remove the Allen wrench from the hole in the push rod housing to apply the correct tension to the timing belt.

9

Turn the crankshaft clockwise two full turns and align the timing marks once again. Replace the upper timing belt cover with a socket wrench. Install any components removed in step one to access the timing belt.