Repair And Fix it

home» 95 » a » buick » century » how » to » troubleshoot » How to Troubleshoot a 95 Buick Century

---

How to Troubleshoot a 95 Buick Century

The 1995 Buick Century was available in Special, Custom and Limited editions, each equipped with front-wheel drive and an automatic transmission. Regardless of the type of Century you own, problems can occur during ownership such as overheating, power steering going out and issues with tires and brakes. You can troubleshoot your vehicle to find the problem and save you a lot of money.

Instructions

1

Open the hood of the car while the engine is running and listen for the sound of the fan(s) running. This is an indication of the engine overheating.

2

Turn the engine off and check the fluid level in your coolant. Wait until the car cools down as it is easy to burn yourself when checking fluid levels of a hot engine. If the coolant is low, refill to the "Full Hot" coolant line. If you notice the fluid leaking, this can indicate a possible leak in your radiator hoses, heater hoses, water pump or another part of the cooling system.

3

Remove the dipstick from the power steering compartment while the engine is off. The power steering compartment is located on the passenger side of the engine. Wipe the dipstick with a clean rag and reinsert. If the fluid level is below the "C" mark you may experience difficulty with the power steering. Add fluid and recheck to verify you have added the right amount.

4

Inspect your tires to see if there are any bulges, cracks or splits in the tire. Check the treadwear of your tires to determine if you need to replace them. Poor tire conditions can lead to flat tires. Also, the cord or fabric inside the tire should not be showing through the rubber.

5

Listen for a high-pitched sound while driving and whether it stops when you press on the brakes. This may be an indication that your brake pads are worn. Unless you are skilled in brake repair, take your car to a repair shop for inspection and possible brake replacement. It is a good idea to have your front and rear brakes checked at the same time.