Repair And Fix it

home» 1991 » assembly » ford » head » lamp » ranger » removal » 1991 Ford Ranger Head Lamp Assembly Removal

---

1991 Ford Ranger Head Lamp Assembly Removal

If the composite headlight assembly in your 1991 Ford Ranger needs replacing due to damage or discoloration, the assembly can be removed from the front of the truck with a little effort and basic tools. The assembly uses screws to hold it in place, and while the trim bezel has to come off first, the screws are all readily accessible. If you need to change the bulbs in these assemblies, do it from the rear of the light without removal.

Instructions

1

Open the hood of the truck and locate the two screws on the top of the trim bezel. Remove them with a Phillips screwdriver then move to the front of the bezel and locate the four screws in the face of it. Remove them with your Phillips screwdriver and set them aside.

2

Pull the trim bezel off the front of the truck and set it aside. There are three clips along the bottom edge of the bezel; they may require you to pull harder than you think you should but they will let go if you pull hard enough.

3

Locate the four screws at the corners of the headlight assembly. Remove the screws with a Phillips screwdriver then pull the headlight assembly toward you until you can reach the headlight bulb connection on the rear off the assembly.

4

Release the locking tab on the headlight bulb and pull the wiring harness connector off the bulb. Set the harness aside and remove the headlight assembly off the truck.