Pages

Showing posts with label into. Show all posts
Showing posts with label into. Show all posts

Saturday, April 19, 2014

What Happens When Water Is Put Into a Cars Gas Tank

What Happens When Water Is Put Into a Cars Gas Tank?

Water and fuel dont mix, so its never a good idea to put water into a cars gas tank. However, when water does get into a gas tank, either accidentally, or as the result of a malicious prank, the result is engine trouble.

Condensation

    Water can get into a gas tank even if you didnt put it there. Sometimes water gets in through a badly sealed cap on the tank, or by natural condensation on the inside of the gas tank

Problems

    Water in the gas tank may lead to the car bucking, stalling or not starting at all, or starting the car could be difficult. This is because the water and fuel separate, especially when the car has been sitting for a while, and the water sinks to the bottom with the fuel on top. Water can also get into other parts of the engine causing rust and corrosion.

Removal

    The method you use to get rid of water in your cars gas tank depends on how much got in there in the first place. In the case of only a little water, an additive that dries up water could be used. The additive combines with the water as it goes through the running engine. If there is a lot of water, a mechanic will have to remove the gas. This may include removing the fuel tank from the car and putting in new filters. The tank is then put back and is filled with clean gas.

ReadMore

Monday, November 11, 2013

How to Switch a 1986 Ford F150 4X4 Into Four Wheel Drive

The 1986 Ford F150 shipped from the factory with two four-wheel drive hub options; automatic locking hubs and manual locking hubs. With manual locking hubs, you need to get out of the vehicle and manually lock the front hubs before the truck will engage the four-wheel drive. With automatic locking hubs, all you need to do is engage the four-wheel drive with a lever and they will automatically lock within a few revolutions of the front wheels. While automatic locking hubs are a nice feature, some owners actually prefer the manual locking hubs because they are less prone to malfunctioning due to their simpler design.

Instructions

    1

    Stop the truck shift it into park, or first gear for trucks equipped with a manual transmission. Apply the parking brake.

    2

    Exit the truck and rotate the locking switch at the center of the wheel hubs to the lock position. If your truck doesnt have these switches, then you have automatic locking hubs and can skip this step.

    3

    Shift the transmission into neutral. Move the four wheel drive selector lever to the left, then down into your desired four wheel drive range. Use 4-LOW for low speeds below 15 miles per hour and increased torque. Use 4-HI for driving at road and highway speeds.

    4

    Shift the transmission back into drive, or first gear for trucks with a manual transmission. Release the parking brake, then drive forward 20 to 25 feet to engage the four-wheel drive hubs.

ReadMore