Repair And Fix it

home» an » carb » ex500 » how » install » to » How to Install an EX500 Carb

---

How to Install an EX500 Carb

The EX500 carburetor is used to bring the right mix of air and fuel into a car engine. When a carb isnt working, the engine will either die or it will take in too much fuel. The EX500 will make the engine run again, but it will also cut down on fuel intake. You dont have to be a mechanic to install the carburetor; you can do it yourself.

Instructions

1

Pop the hood on your car and locate where the carburetor should be installed next to the engine. Clean the intake manifold on the top of the carburetors gasket surface with a rag. Remove the old carburetors gasket with a razor blade.

2

Put the EX500s gasket over the four studs where the carburetor will be installed. Place the EX500 over the four studs and then place it over the gasket.

3

Connect the four retaining nuts over the studs on the corners of the carburetor. Tighten the nuts with a socket wrench. Apply the gasket glue to the gasket and allow it to dry. This should take about four minutes.

4

Put the small hose clamp over the end of the cars fuel line. Connect the fuel line to the fuel inlet on the carburetor. This is on the right side of the carburetor. Slide the larger hose onto the fuel line and then tighten the clamp with a screwdriver.

5

Connect the throttle cable to the cars throttle linkage. This is located on the right side of the carb. Connect the distributor vacuum line to the inlet on your carb. Turn on the car.